This is a good Electronics project report on
Wireless Battery Charger which convert RF/ Microwave to DC and store in battery. This report covers the basis and design of the wireless battery charger. The wireless charger will convert the RF/ microwave signal at 900 MHz frequency into a DC signal, and then store the power into an AAA battery. The project is divided into 3 parts: transmitter, antenna, and charging circuit. Below diagram shows the overall design diagram of Wireless Battery Charger.
You can also Subscribe to FINAL YEAR PROJECT'S by Email for more such Projects and Seminar. You may also like Wireless Charging of Mobile Phone.
This wireless battery charger is designed to operate at 900 MHz. In this project, a power transmitter acts as the power source. It will transmit power to the receiver side. And then, the rectifier circuit in the receiver will convert the RF/ microwave signal into DC signal. After the DC signal is produced, the charging circuit will store the power into the battery. Here is the block diagram of the overall design. Use this report only for your study and reference.
Author:-Eric Lo, Hau Truong, Louis Elnatan, Alvin Mar, Ha Nguyen
DOWNLOAD
Advertisements:-
No comments:
Post a Comment